Andrey Mischuk

Senior Software Engineer.

• Coordinated with engineering teams to assess and optimize hardware and software interfaces.
• Develop firmware for MCU STM32L151 to collect state from light, water, motion sensors, analyze state of power supply.
• Design solutions and realization protocol for data exchange between STM32L151 and STM32WB55RG via IRDA.
• Develop firmware on the MCU side for data exchange between cell phone application and STM32WB55 via BLE and send device state information to the data center via SIM7600 module

My own DIY project. The project's missoion is to teach people how to build low-cost, and incredibly dependable induction heating systems for home. In order to accomplish this, I created and maintain the channel https://dzen.ru/energy4all.ru where I share unique hardware ideas and provide Altium Designer projects. I produce videos that show how to program a prototype heater device.

• MCU STM32H750VBT6 board detect resonance frequence in a parallel LC circuit and maintain it while heating.
• Calculate 1/4 and 3/4 periods resonance frequency, manage power mosfet keys, control and sets the opening duration.
• Storing configuration data, firmware for esp32, in flash memory and store logs on external usb flash drive.
• Board contains esp32 module it's make possible to manage heater device via BLE.
• Processing temperature sensors and send current state of heater to MQTT broker Mosquitto via ESP32 Wi/Fi connection.
• Several heater devices to communicate with each other's via the CAN bus.

• STM32CubeIDE for STM32 programming
• Espressif-IDE for ESP32-WROOM-32U/BLE.
• Own implementation of FORTH interpreter language in c
• PCB design process using Altium Designer CAD Tools

Hardware Design Engineer.

• Design and implementation architecture and hardware design in Altium Designer firmware Programmer for esp8285, esp8286, esp32 chips.
• Built a prototype and transferred into production.
• The Programmer is controlled via the CAN bus by the robotic complex and from the operator's control panel.
• Write firmware to the programmer from PC organized via UART/USB interface.
• The binary firmware for espressif chips is pre-written in the serial flash memory FM25Q16.

The esp8286/esp32 chip programmer software is implemented using the espressif library, development environment for STM32G0B1RET6 was STM32CubeIDE. Win32 console application for migrating binary files into programmer was develpment in IDE eclipse using MinGW.

developed hardware designs (using Altium Designer), created device, built software for reading information from CAN bus of vehicle including engine speed, fuel level in the tank, and vehicle miles and and so forth...

Electronic Design Engineer

Developed new hardware design for overhead and underground lines for the distribution network monitoring system "KOMORSAN" An integrated system - "KOMORSAN" is designed to promptly locate faulty sections and to transmit the corresponding data to dispatching points. The KOMORSAN system improves reliability, productivity (cost) and efficiency of distribution networking.

University of kazakhstan